Automation Webstore is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with Automation Webstore's 1-year warranty.
All Major Credit
Cards Accepted
Type a description for this product here...
All Surplus and Refurbished products come with a 1-Year Automation Webstore Warranty.
The 1762-OW16 by Allen-Bradley and Rockwell Automation is a MicroLogix 1200 Series Relay Output Module. It has 16 outputs and an AC/DC normally open relay voltage category. This controller has an IP20 enclosure type rating. Additional general specifications for the 1762-OW16 include an approximate shipping weight of 285 grams, or 0.63 pounds, and its dimensions are 90 x 40.4 x 87 millimeters, or 3.54 x 1.59 x 3.43 inches. This controller does not have a pilot duty rating. Output specifications for the hardware include an operating voltage range of 5 to 265 Volts AC and 5 to 125 Volts DC. The maximum heat dissipation for the 1762-OW16 is 6.1 Watts and maximum off-state leakage is 0 milliAmps. This hardware has a minimum on-state current of 10 milliAmps. Maximum continuous current per common is 8 Amps and maximum continuous current per module is 16 Amps; maximum total controlled load is 1440 Volt-Amperes. Environmental specifications include an operating temperature between -20 and 65 degrees Celsius and a storage temperature between -40 and 85 degrees Celsius; This hardware has a relative humidity rating of 5% to 95% (non-condensing).
To mount the 1762-OW16 onto a DIN rail, first you must mount your DIN rail, ensuring that the placement of the module on the DIN rail meets the required amount of spacing. Next it is important to make sure that the DIN latch is closed. After this, it is time to hook the top slot on the module on the DIN rail. While pressing down on the module along the top of the rail, secure the bottom part of the module into position. It is important that the installer leave the protective wrapping on the module until the wiring process is complete. The 1762-OW16 can be mounted to EN50022-35x7.5 or EN50022-35x15 DIN rails. To remove this hardware from a DIN rail, first place a flathead screwdriver inside the DIN rail latch, located at the bottom of the controller. Next, holding the controller, pry in a downward motion on the latch until the latch is locked into its open position. Repeat the previous two steps for the second DIN rail latch, then unhook the top of the DIN rail slot from the rail.VIIIVThe 1762-OW16 by Allen-Bradley and Rockwell Automation is a MicroLogix 1200 Series Relay Output Module. It has 16 outputs and an AC/DC normally open relay voltage category. This hardware has an IP20 enclosure type rating.