Automation Webstore is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with Automation Webstore's 1-year warranty.
All Major Credit
Cards Accepted
Type a description for this product here...
All Surplus and Refurbished products come with a 1-Year Automation Webstore Warranty.
The 1762-L40BWA is a MicroLogix 1200 Series Programmable Controller by Allen-Bradley and Rockwell Automation. Input power for this hardware is 120/240 Volts AC. There is a total of 24 inputs (20 24-Volt DC inputs, 4 fast 24-Volt DC inputs) and 16 relay outputs. Maximum operating temperature for this hardware is 55 degrees Celsius while its minimum operating temperature is 0 degrees Celsius. Operating supply voltage for the 1762-L40BWA is 240 Volts. The dimensions for this product are 90 millimeters for its depth, 87 millimeters for its length, and 160 millimeters for width. Line power for the 1762-L40BWA is 85/265 Volts AC while user power input is 24 Volts DC at 400 milliAmps. The input circuit type for this product is 24 Volts DC, sink/source. On-state voltage range for inputs 0 through 3 is 14 to 26.4 Volts DC at 55 degrees Celsius and 14 to 30 Volts DC at 30 degrees Celsius. On-state voltage range for inputs 4 and higher is 10 to 26.4 Volts DC at 55 degrees Celsius and 10 to 30 Volts DC at 30 degrees Celsius. Off-state leakage current is 1.5 milliAmps (minimum).
To mount the 1762-L40BWA onto a DIN rail, first you must mount your DIN rail, ensuring that the placement of the module on the DIN rail meets the required amount of spacing. Next you must ensure that the DIN latch is closed. After this, it is time to hook the top slot on the module over the DIN rail. While pressing down on the module against the top of the rail, secure the bottom part of the module into position. It is recommended that the installer leave the protective wrapping on the module until the wiring process is complete. The 1762-L40BWA can be mounted to EN50022-35x7.5 or EN50022-35x15 DIN rails. To remove this hardware from a DIN rail, first place a flathead screwdriver in the DIN rail latch at the bottom of the controller. Next, holding the controller, pry in a downward motion on the latch until the latch is locked into its open position. Repeat the previous two steps for the second DIN rail latch, then unhook the top of the DIN rail slot from the rail.VIIIVThe 1762-L40BWA by Allen-Bradley and Rockwell Automation is a MicroLogix 1200 Series Programmable Controller. This controller has an input power of 120/240 Volts AC. It has 20 24-Volt DC inputs and 4 fast 24-Volt DC inputs, totaling at 24 inputs. The 1762-L40BWA has 16 relay outputs.