Hover over image to zoom
Automation Webstore is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with Automation Webstore's 1-year warranty.
All Major Credit
Cards Accepted
Type a description for this product here...
All Surplus and Refurbished products come with a 1-Year Automation Webstore Warranty.
The 1762-OV32T is a MicroLogix 1200 Series Solid State 24 Volt DC Sink Output Module by Allen-Bradley and Rockwell Automation. It has 32 outputs and has an IP20 enclosure type rating. This hardware has an operating voltage range between 10.2 and 26.4 Volts DC. General specifications for the 1762-OV32T include a maximum bus current draw of 175 milliAmps at 5 Volts DC and 0 milliAmps at 24 Volts DC. The heat dissipation for this device is 2.7 Watts at 26.4 Volts DC. This hardware does not have a pilot duty rating. The dimensions for the controller are 90 x 40.4 x 87 millimeters, or 3.54 x 1.59 x 3.43 inches. The approximate shipping weight for the 1762-OV32T is 200 grams, or 7.05 ounces. Output specifications include a voltage category of 24 Volt DC Sink and a minimum on-state current of 1.0 milliAmp. The maximum off-state leakage current is 0.1 milliAmp at 26.4 Volts DC. Maximum on-state voltage drop is 0.3 Volts DC at 0.5 Amps. The maximum continuous current per point is 0.5 Amps at 60 degrees Celsius. Environmental specifications for the 1762-OV32T include an operating temperature between -20 and 60 degrees Celsius and a storage temperature between -40 and 85 degrees Celsius.
To mount the 1762-OV32T onto a DIN rail, first you must mount your DIN rail, ensuring that the placement of the module on the DIN rail meets the required amount of spacing. Next it is important to make sure that the DIN latch is closed. After this, it is time to hook the top slot on the module on the DIN rail. While pressing down on the module along the top of the rail, secure the bottom part of the module into position. It is important that the installer leave the protective wrapping on the module until the wiring process is complete. The 1762-OV32T can be mounted to EN50022-35x7.5 or EN50022-35x15 DIN rails. To remove this hardware from a DIN rail, first place a flathead screwdriver inside the DIN rail latch, located at the bottom of the controller. Next, holding the controller, pry in a downward motion on the latch until the latch is locked into its open position. Repeat the previous two steps for the second DIN rail latch, then unhook the top of the DIN rail slot from the rail.VIIIVThe 1762-OV32T is a MicroLogix 1200 Series Solid State 24 Volt DC Sink Output Module and is manufactured by Allen-Bradley and Rockwell Automation. It has 32 outputs and has an IP20 enclosure type rating. This hardware has a voltage category of 24 Volts DC, Sink.