Hover over image to zoom
Automation Webstore is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with Automation Webstore's 1-year warranty.
All Major Credit
Cards Accepted
All Surplus and Refurbished products come with a 1-Year Automation Webstore Warranty.
The 2711P-RDB7C is a PanelView Plus accessory that is used to replace an existing display module. This display module features a 6.5-inch colored graphic display, with resolution of 640 x 480 and display area of 132 x 99 mm (5.20 x 3.90 in).
PanelView Plus terminals provides the operator real-time view of the process or machine in the factory floor area. It may be installed indoor and outdoor thus, exposing the unit to elements that may affect the performance of the entire unit. This exposure has direct impact to the display module.
Due to this instance, the display module is recommended to be regularly cleaned. When cleaning the module, use a soft cloth, dipped to a mild soap or detergent solution. Gently wipe the screen with the power switched off. After wiping, use a sponge to clean-up wet areas and absorb water pockets. For oil, grease or paint, 70% Isopropyl alcohol may be used for removal of these contaminant. After removal, use a soft cloth dipped with mild soap and finish cleaning with the use of a sponge. Always apply adequate pressure to the screen, around 10 t o110 g. Additionally, anti-glare overlay may be used to promote easier cleanup and improve screen vision.
Upon start-up of the module, brightness is set at 50%. Depending on the installation location, adjust the brightness and contrast to fine tune display setting. This may be done through the Display terminal settings. Additionally, screen temperature may also be viewed in the same category setting as well as setting of screen saver.VIIIVThe 2711P-RDB7C is a display module compatible for use with PanelView Plus 700. This module features 6.5-inch colored screen for Touch and Key operated terminals.